Seal Installation Instructions

• Remove the plastic dust cover from the rear center of the motor.
  
  
• Use a flat tip screwdriver to hold the impeller still by placing it down the outlet of the wet end and into a impeller slot.
  
  
• While holding the screwdriver in the impeller steady, place a wide flat tip screwdriver in the slot that was behind the dust cover and turn 2-3 times counter clockwise.
  
  
• Now loosen out the four 1/4” nut screws along the rear perimeter of the motor.
  
  
• Remove the wet end from the motor by repeating the counter clockwise turns in step number 3.
  
  
• Use a Phillips screwdriver to remove the faceplate bolts on the wet end.
  
  
• Remove the old seal by tapping the seal from the out side of the wet end inward.
  
  
• Clean out all the old seal adhesive and dirt from the wet end and wet cleaned area with purple PVC primer.
  
  
• Place the new seal in a 1” PVC coupling black side down into the PVC coupling).
  
  
• Cover the stainless edge facing you with clear 100% silicone.
  
  
• While holding the PVC coupling, press the new seal into the same position of the old seal.
  
  
• Remove and replace the ceramic bushing on back of the impeller, making sure it is in straight.
  
  
• Reassemble the unit and allow to cure for 24 hours.
  

NOTE: All seals installed by owners and service providers are NOT guaranteed against leakage.